F3726, F3211, F3174, R5135, R3816-HP Firewalls and UTM Devices Network Management Command Reference-6PW100

91
Usage guidelines
The MSTP statistics information includes the numbers of TCN BPDUs, configuration BPDUs, RST BPDUs
and MST BPDUs sent/received through the specified ports.
Examples
# Clear the spanning tree-related statistics on ports GigabitEthernet 0/1 through GigabitEthernet 0/3.
<Sysname> reset stp interface gigabitethernet 0/1 to gigabitethernet 0/3
Related commands
display stp
revision-level
Use revision-level to configure the MSTP revision level.
Use undo revision-level to restore the default MSTP revision level.
Syntax
revision-level level
undo revision-level
Default
The MSTP revision level is 0.
Views
MST region view
Default command level
2: System level
Parameters
level: Specifies an MSTP revision level, ranging from 0 to 65535.
Usage guidelines
The MSTP revision level, the MST region name, and the VLAN-to-instance mapping table of a device
determine the device's MST region. When the MST region name and VLAN-to-instance mapping table
are both the same for two MST regions, they can still be differentiated by their MSTP revision levels.
After configuring this command, run the active region-configuration command to activate the configured
MST region level.
Examples
# Set the MSTP revision level of the MST region to 5.
<Sysname> system-view
[Sysname] stp region-configuration
[Sysname-mst-region] revision-level 5
Related commands
• active region-configuration
• check region-configuration
• display stp region-configuration
• instance