F3726, F3211, F3174, R5135, R3816-HP Firewalls and UTM Devices Network Management Command Reference-6PW100

100
Configured in Ethernet interface view, the setting takes effect only on the interface.
Configured in Layer 2 aggregate interface view, the setting takes effect only on the aggregate interface.
Configured on a member port in an aggregation group, the setting takes effect only after the port leaves
the aggregation group.
Examples
# Perform mCheck on GigabitEthernet 0/1.
<Sysname> system-view
[Sysname] interface gigabitethernet 0/1
[Sysname-GigabitEthernet0/1] stp mcheck
Related commands
stp mode
stp mode
Use stp mode to configure the spanning tree operating mode.
Use undo stp mode to restore the default.
Syntax
stp mode { mstp | rstp | stp }
undo stp mode
Default
A spanning tree device operates in MSTP mode.
Views
System view
Default command level
2: System level
Parameters
mstp: Configures the spanning tree device to operate in MSTP mode.
rstp: Configures the spanning tree device to operate in RSTP mode.
stp: Configures the spanning tree device to operate in STP mode.
Usage guidelines
MSTP mode is compatible with RSTP mode, RSTP mode is compatible with STP mode.
Examples
# Configure the spanning tree device to operate in STP mode.
<Sysname> system-view
[Sysname] stp mode stp
Related commands
• stp enable
• stp mcheck