F3726, F3211, F3174, R5135, R3816-HP Firewalls and UTM Devices Network Management Command Reference-6PW100

189
Parameters
ascii: Specifies the code type for the circuit ID sub-option as ascii.
hex: Specifies the code type for the circuit ID sub-option as hex.
Usage guidelines
This command applies to configuring the non-user-defined circuit ID sub-option only. After you configure
the padding content for the circuit ID sub-option by using the dhcp relay information circuit-id string
command, ASCII is adopted as the code type.
Examples
# Configure the code type for the non-user-defined circuit ID sub-option as hex.
<Sysname> system-view
[Sysname] interface gigabitethernet0/1
[Sysname-GigabitEthernet0/1] dhcp relay information circuit-id format-type hex
Related commands
display dhcp relay information
dhcp relay information circuit-id string
Use dhcp relay information circuit-id string to configure the padding content for the user-defined circuit
ID sub-option.
Use undo dhcp relay information circuit-id string to restore the default.
Syntax
dhcp relay information circuit-id string circuit-id
undo dhcp relay information circuit-id string
Default
The padding content for the circuit ID sub-option depends on the padding format of Option 82.
Views
Interface view
Default command level
2: System level
Parameters
circuit-id: Padding content for the user-defined circuit ID sub-option, a case-sensitive string of 3 to 63
characters.
Usage guidelines
After you configure the padding content for the circuit ID sub-option by using this command, ASCII is
adopted as the code type.
Examples
# Configure the padding content for the circuit ID sub-option as company001.
<Sysname> system-view
[Sysname] interface gigabitethernet 0/1
[Sysname-GigabitEthernet0/1] dhcp relay information circuit-id string company001