F3726, F3211, F3174, R5135, R3816-HP Firewalls and UTM Devices Network Management Command Reference-6PW100

293
Use undo preference to restore the default.
Syntax
preference [ route-policy route-policy-name ] value
undo preference [ route-policy ]
Default
The preference of RIP routes is 100.
Views
RIP view
Default command level
2: System level
Parameters
route-policy-name: Specifies a routing policy by its name, a case-sensitive string of 1 to 63 characters.
value: Specifies a preference for RIP routes, in the range of 1 to 255. The smaller the value, the higher the
preference.
Usage guidelines
You can specify a routing policy by using the keyword route-policy to set a preference for matching RIP
routes.
• The preference set by the routing policy applies to all matching RIP routes. The preference of other
routes is set by the preference command.
• If no preference is set by the routing policy, the preference of all RIP routes is set by the preference
command.
Examples
# Set a preference of 120 for RIP routes.
<Sysname> system-view
[Sysname] rip 1
[Sysname-rip-1] preference 120
reset rip process
Use reset rip process to reset a RIP process.
Syntax
reset rip process-id process
Views
User view
Default command level
1: Monitor level
Parameters
process-id: Specifies a RIP process by its ID in the range of 1 to 65535.
Usage guidelines
After you execute the command, you are prompted to confirm the operation.