F3726, F3211, F3174, R5135, R3816-HP Firewalls and UTM Devices Network Management Command Reference-6PW100

301
[Sysname-route-policy] apply cost 6
[Sysname] interface gigabitethernet 0/1
[Sysname-GigabitEthernet0/1] rip metricout route-policy abc 2
rip mib-binding
Use rip mib-binding to bind MIB operations with a specified RIP process, so that the RIP process can
receive SNMP requests.
Use undo rip mib-binding to restore the default.
Syntax
rip mib-binding process-id
undo rip mib-binding
Default
MIB operations are bound to RIP process 1. RIP process 1 is enabled to receive SNMP requests.
Views
System view
Default command level
2: System level
Parameters
process-id: RIP process ID, in the range of 1 to 65535.
Examples
# Enable RIP process 100 to receive SNMP requests.
<Sysname> system-view
[Sysname] rip mib-binding 100
# Restore the default.
[Sysname] undo rip mib-binding
rip output
Use rip output to enable the interface to send RIP messages.
Use undo rip output to disable the interface from sending RIP messages.
Syntax
rip output
undo rip output
Default
Sending RIP messages is enabled on an interface.
Views
Interface view
Default command level
2: System level