F3726, F3211, F3174, R5135, R3816-HP Firewalls and UTM Devices Network Management Command Reference-6PW100

347
Parameters
protocol: Redistributes routes from the specified protocol, which can be bgp, direct, isis, ospf, rip, or
static.
The following matrix shows the values for the protocol argument on different firewalls and UTM devices:
Hardware Protocols
F1000-A-EI/F1000-S-EI bgp, direct, ospf,rip, and static
F1000-E bgp, direct, ospf, rip, and static
F5000 bgp, direct, isis, ospf, rip, and static
Firewall module direct, ospf, rip, and static
U200-A bgp, direct, ospf, rip, and static
U200-S direct, ospf, rip, and static
process-id: Specifies an process by its ID in the range of 1 to 65535. The default is 1. It is available only
when the protocol is isis, rip, or ospf.
all-processes: Redistributes routes from all the processes of the specified routing protocol. This keyword
takes effect only when the protocol is isis, rip, or ospf.
allow-ibgp: Allows IBGP routes redistribution. It is available only when the protocol is bgp.
cost cost: Specifies a route cost, in the range of 0 to 16777214. The default is 1.
type type: Specifies a cost type, 1 or 2. The default is 2.
tag tag : Specifies a tag for external LSAs. The default is 1.
route-policy route-policy-name: Uses the specified routing policy to filter redistributed routes. The
route-policy-name argument is a case-sensitive string of 1 to 63 characters.
Usage guidelines
OSPF prioritize routes into the following levels:
• Intra-area route
• Inter-area route
• Type-1 external route
• Type-2 external route
An intra-area route is a route in an OSPF area. An inter-area route is between any two OSPF areas. Both
of them are internal routes.
An external route is a route to a destination outside the OSPF AS.
A Type-1 external route has high reliability. Its cost is comparable with the cost of OSPF internal routes.
The cost from an OSPF router to a Type-1 external route's destination equals the cost from the router to the
ASBR plus the cost from the ASBR to the external route’s destination.
A Type-2 external route has low credibility. OSPF considers the cost from the ASBR to the destination of
a Type-2 external route is much bigger than the cost from the ASBR to an OSPF internal router. The cost
from an internal router to a Type-2 external route's destination equals the cost from the ASBR to the Type-2
external route’s destination.
The import-route command cannot redistribute default routes.