F3726, F3211, F3174, R5135, R3816-HP Firewalls and UTM Devices Network Management Command Reference-6PW100

361
directly connected, you must configure the P2MP network type so that the two routers can exchange
routing information via another router.
When the network type of an interface is NBMA or P2MP unicast, you must use the peer command to
specify the neighbor.
If only two routers run OSPF on a network, you can configure the network type for the connected
interfaces as P2P.
When the network type of an interface is P2MP unicast, all OSPF packets are unicast by the interface.
Examples
# Configure the NBMA network type for GigabitEthernet 0/1.
<Sysname> system-view
[Sysname] interface gigabitethernet 0/1
[Sysname-GigabitEthernet0/1] ospf network-type nbma
Related commands
ospf dr-priority
ospf packet-process prioritized-treatment
Use ospf packet-process prioritized-treatment to enable OSPF to give priority to receiving and
processing hello packets.
Use undo ospf packet-process prioritized-treatment to restore the default.
Syntax
ospf packet-process prioritized-treatment
undo ospf packet-process prioritized-treatment
Default
This function is not enabled.
Views
System view
Default command level
2: System level
Examples
# Enable OSPF to give priority to receiving and processing hello packets.
<Sysname> system-view
[Sysname] ospf packet-process prioritized-treatment
ospf timer dead
Use ospf timer dead to set the neighbor dead interval.
Use undo ospf timer dead to restore the default.
Syntax
ospf timer dead seconds
undo ospf timer dead