F3726, F3211, F3174, R5135, R3816-HP Firewalls and UTM Devices Network Management Command Reference-6PW100

Table Of Contents

370

Parameters

interface-type interface-number: Specifies an interface by its type and number.

all: Specifies all interfaces.

Usage guidelines

A disabled interface is a passive interface that cannot send any hello packets.

To disable a network from receiving OSPF routes, issue the command on the interface connected to the

network.

Examples

# Disable interface GigabitEthernet 0/1 from sending OSPF packets.

<Sysname> system-view

[Sysname] ospf 100

[Sysname-ospf-100] silent-interface gigabitethernet 0/1

snmp-agent trap enable ospf

Use snmp-agent trap enable ospf to enable the sending of SNMP traps for a specified OSPF process.

Use undo snmp-agent trap enable ospf to disable the feature.

Syntax

snmp-agent trap enable ospf [ process-id ] [ ifauthfail | ifcfgerror | ifrxbadpkt | ifstatechange |

undo snmp-agent trap enable ospf [ process-id ] [ ifauthfail | ifcfgerror | ifrxbadpkt | ifstatechange |

Default

This feature is enabled.

Views

System view

Default command level

3: Manage level

Parameters

process-id: Specifies an OSPF process by its ID in the range of 1 to 65535.

ifauthfail: Specifies information about interface authentication failures.

ifcfgerror: Specifies information about interface configuration errors.

ifrxbadpkt: Specifies information about error packets received.

ifstatechange: Specifies information about interface state changes.

iftxretransmit: Specifies information about packet receiving and forwarding.

lsdbapproachoverflow: Specifies information about cases approaching LSDB overflow.

lsdboverflow: Specifies LSDB overflow information.