F3726, F3211, F3174, R5135, R3816-HP Firewalls and UTM Devices Network Management Command Reference-6PW100

371
maxagelsa: Specifies LSA max age information.
nbrstatechange: Specifies information about neighbor state changes.
originatelsa: Specifies information about LSAs originated locally.
vifauthfail: Specifies information about virtual interface authentication failures.
vifcfgerror: Specifies information about virtual interface configuration errors.
virifauthfail: Specifies information about virtual interface authentication failures.
virifrxbadpkt: Specifies information about error packets received by virtual interfaces.
virifstatechange: Specifies information about virtual interface state changed.
viriftxretransmit: Specifies information about virtual interface packet retransmission.
virnbrstatechange: Specifies information about virtual interface neighbor state changed.
Usage guidelines
If no process is specified, the command enables the sending of SNMP traps for all OSPF processes.
For related information, see System Management and Maintenance Command Reference.
Examples
# Enable the sending of SNMP traps for OSPF process 1.
<Sysname> system-view
[Sysname] snmp-agent trap enable ospf 1
spf-schedule-interval
Use spf-schedule-interval to set the OSPF SPF calculation interval.
Use undo spf-schedule-interval to restore the default.
Syntax
spf-schedule-interval maximum-interval [ minimum-interval [ incremental-interval ] ]
undo spf-schedule-interval
Default
The interval defaults to 5 seconds.
Views
OSPF view
Default command level
2: System level
Parameters
maximum-interval: Specifies the maximum OSPF route calculation interval in seconds, in the range of 1
to 60.
minimum-interval: Specifies the minimum OSPF route calculation interval in milliseconds, in the range of
10 to 60000, which defaults to 0.
incremental-interval: Specifies the incremental value in milliseconds, in the range of 10 to 60000. The
default is 5000.