F3726, F3211, F3174, R5135, R3816-HP Firewalls and UTM Devices Network Management Command Reference-6PW100

418
Views
Interface view
Default command level
2: System level
Parameters
process-id: Specifies a IS-IS process ID, ranging from 1 to 65535. The default is 1.
Examples
# Create IS-IS routing process 1, and enable it on the GigabitEthernet 1/1 interface.
<Sysname> system-view
[Sysname] isis 1
[Sysname-isis-1] network-entity 10.0001.1010.1020.1030.00
[Sysname-isis-1] quit
[Sysname] interface gigabitethernet 1/1
[Sysname-GigabitEthernet1/1] isis enable 1
Related commands
• isis
• network-entity
isis mesh-group
NOTE:
This command is not available in loopback interface view.
Use isis mesh-group to add the interface into a specified mesh group or block the interface.
Use undo isis mesh-group to restore the default.
Syntax
isis mesh-group { mesh-group-number | mesh-blocked }
undo isis mesh-group
Default
An interface does not belong to any mesh group.
Views
Interface view
Default command level
2: System level
Parameters
mesh-group-number: Mesh group number, ranging from 1 to 4294967295.
mesh-blocked: Blocks the interface, which sends LSPs only after receiving LSP requests.