F3726, F3211, F3174, R5135, R3816-HP Firewalls and UTM Devices Network Management Command Reference-6PW100

420
undo isis peer-ip-ignore
Default
The PPP interface checks the peer's IP address upon receiving a hello packet.
Views
Interface view
Default command level
2: System level
Usage guidelines
An IS-IS PPP interface requires the sender of a hello packet must be on the same network segment as it.
Otherwise, it discards the hello packet. You can use the isis peer-ip-ignore command to disable this
restriction.
Examples
# Configure Virtual-Template 1 not to check the peer’s IP address in the received Hello packets.
<Sysname> system-view
[Sysname] interface Virtual-Template 1
[Sysname-Virtual-Template1] isis enable
[Sysname-Virtual-Template 1] isis peer-ip-ignore
isis silent
Use isis silent to disable the interface from sending and receiving IS-IS packets.
Use undo isis silent to restore the default.
Syntax
isis silent
undo isis silent
Default
An interface is not disabled from sending and receiving IS-IS packets.
Views
Interface view
Default command level
2: System level
Usage guidelines
The feature is not supported on the loopback interface.
Examples
# Disable GigabitEthernet 1/1 from sending and receiving IS-IS packets.
<Sysname> system-view
[Sysname] interface gigabitethernet 1/1
[Sysname-GigabitEthernet1/1] isis silent