F3726, F3211, F3174, R5135, R3816-HP Firewalls and UTM Devices Network Management Command Reference-6PW100

428
Default
SNMP Trap is enabled.
Views
IS-IS view
Default command level
2: System level
Examples
# Enable SNMP Trap.
<Sysname> system-view
[Sysname] isis 1
[Sysname-isis-1] is-snmp-traps enable
log-peer-change (IS-IS view)
Use log-peer-change to enable the logging of IS-IS neighbor state changes.
Use undo log-peer-change to disable the logging.
Syntax
log-peer-change
undo log-peer-change
Default
The logging is enabled.
Views
IS-IS view
Default command level
2: System level
Usage guidelines
After the logging is enabled, information about IS-IS adjacency state changes is sent to the configuration
terminal.
Examples
# Enable logging on the IS-IS adjacency state changes.
<Sysname> system-view
[Sysname] isis 1
[Sysname-isis-1] log-peer-change
lsp-fragments-extend
Use lsp-fragments–extend to enable an LSP fragment extension mode for a level.
Use undo lsp-fragments–extend to disable LSP fragment extension for a level.
Syntax
lsp-fragments-extend [ [ level-1 | level-1-2 | level-2 ] | [ mode-1 | mode-2 ] ] *