F3726, F3211, F3174, R5135, R3816-HP Firewalls and UTM Devices Network Management Command Reference-6PW100

429
undo lsp-fragments-extend
Default
LSP fragment extension is disabled.
Views
IS-IS view
Default command level
2: System level
Parameters
level-1: Applies the fragment extension mode to Level-1 LSPs.
level-1-2: Applies the fragment extension mode to both Level-1 and Level-2 LSPs.
level-2: Applies the fragment extension mode to Level-2 LSPs.
mode-1: Specifies the fragment extension mode 1, used on a network where some routers do not support
LSP fragment extension.
mode-2: Specifies the fragment extension mode 2, used on a network where all routers support LSP
fragment extension.
Usage guidelines
If no mode is specified, LSP fragment extension mode 1 is enabled.
If no level is specified, the LSP fragment extension mode is enabled for both Level-1 and Level-2.
Examples
# Enable LSP fragment extension mode 1 for Level-2.
<Sysname> system-view
[Sysname] isis 1
[Sysname-isis-1] lsp-fragments-extend mode-1 level-2
lsp-length originate
Use lsp-length originate to configure the maximum size of generated Level-1 or Level-2 LSPs.
Use undo lsp-length originate to restore the default.
Syntax
lsp-length originate size [ level-1 | level-2 ]
undo lsp-length originate [ level-1 | level-2 ]
Default
The maximum size of generated Level-1 and Level-2 LSPs is 1497 bytes.
Views
IS-IS view
Default command level
2: System level
Parameters
size: Specifies the maximum size in bytes of LSP packets, ranging from 512 to 16384.