F3726, F3211, F3174, R5135, R3816-HP Firewalls and UTM Devices Network Management Command Reference-6PW100

25
[Sysname] interface gigabitethernet 0/1.1
[Sysname-GigabitEthernet0/1.1] broadcast-suppression 20
mdi
Use mdi to configure the MDI mode of an Ethernet copper interface.
Use undo mdi to restore the default.
Syntax
mdi { across | auto | normal }
undo mdi
Default
Ethernet interfaces operate in auto MDI mode.
Views
Layer 2 Ethernet interface view
Default command level
2: System level
Parameters
across: Sets the MDI mode to across. In this mode, pins 1 and 2 are receive pins, and pins 3 and 6 are
transmit pins.
auto: Sets the MDI mode to auto. In this mode, the port negotiates pin roles with its peer.
normal: Sets the MDI mode to normal. In normal mode, pins 1 and 2 are transmit pins, and pins 3 and
6 are receive pins.
Examples
# Set GigabitEthernet 0/1 to operate in across MDI mode.
<Sysname> system-view
[Sysname] interface gigabitethernet 0/1
[Sysname-GigabitEthernet0/1] mdi across
multicast-suppression
Use multicast-suppression to set the multicast suppression threshold on an Ethernet interface or
subinterface.
Use undo multicast-suppression to restore the default multicast suppression threshold.
Syntax
multicast-suppression ratio
undo multicast-suppression
Default
Ethernet interfaces do not suppress multicast traffic.
Views
Layer 2 Ethernet interface view, Layer 2 Ethernet subinterface view