F3726, F3211, F3174, R5135, R3816-HP Firewalls and UTM Devices Network Management Command Reference-6PW100

543
undo apply output-interface
Views
Policy node view
Default command level
2: System level
Parameters
interface-type interface-number: Specifies an output interface by its type and number.
ip-address next-hop dhcpc: Specifies the gateway address learned through DHCP as the next hop.
Usage guidelines
The following matrix shows the command and firewall compatibility:
The following matrix shows the apply output-interface ip-address next-hop dhcpc command and
firewalls and UTM devices compatibility:
Hardware Command com
p
atible
F1000-A-EI/F1000-S-EI No
F1000-E No
F5000 No
Firewall module No
U200-A No
U200-S Yes
Examples
# Specify the management subinterface GigabitEthernet 0/1.1 as the output interface. (Because
GigabitEthernet 0/1.1 obtains its IP address through DHCP and the next hop address is unknown, you
need to specify the gateway address learned through DHCP as the next hop address.)
<Sysname> system-view
[Sysname] policy-based-route management permit node 1
[Sysname-pbr-management-1] apply output-interface gigabitethernet 0/1.1 ip-address
next-hop dhcpc
display ip policy-based-route
Use display ip policy-based-route to display information about local PBR and interface PBR.
Syntax
display ip policy-based-route [ | { begin | exclude | include } regular-expression ]
Views
Any view
Default command level
1: Monitor level