F3726, F3211, F3174, R5135, R3816-HP Firewalls and UTM Devices Network Management Command Reference-6PW100

31
Last clearing of counters: Never
Last 300 seconds input: 0 bytes/sec, 0 bits/sec, 0 packets/sec
Last 300 seconds output: 0 bytes/sec, 0 bits/sec, 0 packets/sec
0 packets input, 0 bytes, 0 drops
0 packets output, 0 bytes, 0 drops
# Display brief information about interface loopback 0.
<Sysname> display interface loopback 0 brief
The brief information of interface(s) under route mode:
Link: ADM - administratively down; Stby - standby
Protocol: (s) - spoofing
Interface Link Protocol Main IP Description
Loop0 UP UP(s) --
# Display brief information about all loopback interfaces in DOWN state.
<Sysname> display interface loopback brief down
The brief information of interface(s) under route mode:
Link: ADM - administratively down; Stby - standby
Interface Link Cause
Loop1 ADM Administratively
Table 8 Command output
Field Descri
p
tion
current state
Physical state of the interface:
• up.
• administratively down.
Line protocol current state
State of the data link layer protocol: up (spoofing). Spoofing
refers to the spoofing attribute of the interface. When the network
layer protocol state of the interface is displayed as up, the
corresponding link may not exist, or the corresponding link is
non-permanent and established on demand.
Description Description of the interface.
The Maximum Transmit Unit MTU of the interface.
Internet protocol processing
State (enabled or disabled) of the network layer protocol
(displayed as Internet Address is X.X.X.X/XX Primary).
Physical is loopback The physical type of the interface is loopback.
Last clearing of counters
Last time when statistics on the logical interface were cleared by
using the reset counters interface command.
If the statistics have never been cleared since the device started,
this field displays Never.
Last 300 seconds input: 0 bytes/sec, 0
bits/sec, 0 packets/sec
Average input rate over the last 300 seconds in Bps, bps, and
pps.
Last 300 seconds output: 0 bytes/sec, 0
bits/sec, 0 packets/sec
Average output rate over the last 300 seconds in Bps, bps, and
pps.
0 packets input, 0 bytes, 0 drops
Total number and size (in bytes) of input packets on the interface
and the number of dropped packets.
0 packets output, 0 bytes, 0 drops
Total number and size (in bytes) of output packets on the interface
and the number of dropped packets.