F3726, F3211, F3174, R5135, R3816-HP Firewalls and UTM Devices Network Management Command Reference-6PW100

638
undo jp-queue-size
Default
A join/prune messages contains a maximum of 1020 (S, G) entries.
Views
Public network PIM view
Default command level
2: System level
Parameters
queue-size: Specifies the maximum number of (S, G) entries in each join/prune message, in the range of
1 to 4096.
Usage guidelines
When you use this command, take the following into account:
• The size of the forwarding table. In a network that does not support packet fragmentation, if you
configure a large queue size, a join/prune message might contain a large number of groups. This
might cause the message length to exceed the MTU of the network. As a result, the products that do
not support fragmentation drop the join/prune message.
• The (S, G) join/prune timeout timer on the upstream device. If you configure a small queue size, the
outgoing interface of the corresponding entry might have been pruned because of to timeout before
the last join/prune message in a queue reaches the upstream device.
Examples
# Configure each join/prune message to contain a maximum of 2000 (S, G) entries on the public
network.
<Sysname> system-view
[Sysname] pim
[Sysname-pim] jp-queue-size 2000
Related commands
• holdtime join-prune
• jp-pkt-size
• pim holdtime join-prune
pim
Use pim to enter public network PIM view.
Use undo pim to remove all configurations in public network PIM view.
Syntax
pim
undo pim
Views
System view
Default command level
2: System level