F3726, F3211, F3174, R5135, R3816-HP Firewalls and UTM Devices Network Management Command Reference-6PW100

640
Default
PIM-DM is disabled.
Views
Interface view
Default command level
2: System level
Usage guidelines
This command can take effect only after IP multicast routing is enabled.
PIM-DM cannot be used for multicast groups in the SSM group range.
Examples
# Enable IP multicast routing on the public network, and enable PIM-DM on GigabitEthernet 0/1.
<Sysname> system-view
[Sysname] multicast routing-enable
[Sysname] interface gigabitethernet 0/1
[Sysname-GigabitEthernet0/1] pim dm
Related commands
• multicast routing-enable
• pim sm
• ssm-policy
pim hello-option dr-priority
Use pim hello-option dr-priority to configure the router priority for DR election on the current interface.
Use undo pim hello-option dr-priority to restore the default.
Syntax
pim hello-option dr-priority priority
undo pim hello-option dr-priority
Default
The router priority for DR election is 1.
Views
Interface view
Default command level
2: System level
Parameters
priority: Specifies a router priority for DR election, in the range of 0 to 4294967295. A larger value
indicates a higher priority.
Examples
# Set the router priority for DR election to 3 on GigabitEthernet 0/1.
<Sysname> system-view