F3726, F3211, F3174, R5135, R3816-HP Firewalls and UTM Devices Network Management Command Reference-6PW100

647
Examples
# Disable state refresh on GigabitEthernet 0/1.
<Sysname> system-view
[Sysname] interface gigabitethernet 0/1
[Sysname-GigabitEthernet0/1] undo pim state-refresh-capable
Related commands
• state-refresh-interval
• state-refresh-rate-limit
• state-refresh-ttl
pim timer graft-retry
Use pim timer graft-retry to configure the graft retry period.
Use undo pim timer graft-retry to restore the default.
Syntax
pim timer graft-retry interval
undo pim timer graft-retry
Default
The graft retry period is 3 seconds.
Views
Interface view
Default command level
2: System level
Parameters
interval: Specifies a graft retry period in seconds. The value ranges from 1 to 65535.
Examples
# Set the graft retry period to 80 seconds on GigabitEthernet 0/1.
<Sysname> system-view
[Sysname] interface gigabitethernet 0/1
[Sysname-GigabitEthernet0/1] pim timer graft-retry 80
pim timer hello
Use pim timer hello to configure the interval at which hello messages are sent on the current interface.
Use undo pim timer hello to restore the default.
Syntax
pim timer hello interval
undo pim timer hello
Default
Hello messages are sent at the interval of 30 seconds.