F3726, F3211, F3174, R5135, R3816-HP Firewalls and UTM Devices Network Management Command Reference-6PW100

649
pim triggered-hello-delay
Use pim triggered-hello-delay to configure the maximum delay between hello messages.
Use undo pim triggered-hello-delay to restore the default.
Syntax
pim triggered-hello-delay interval
undo pim triggered-hello-delay
Default
The maximum delay between hello messages is 5 seconds.
Views
Interface view
Default command level
2: System level
Parameters
interval: Specifies the maximum delay in seconds between hello messages. The value ranges from 1 to
60.
Examples
# Set the maximum delay between hello messages to 3 seconds on GigabitEthernet 0/1.
<Sysname> system-view
[Sysname] interface gigabitethernet 0/1
[Sysname-GigabitEthernet0/1] pim triggered-hello-delay 3
probe-interval (PIM view)
Use probe-interval to configure the register probe time.
Use undo probe-interval to restore the default.
Syntax
probe-interval interval
undo probe-interval
Default
The register probe time is 5 seconds.
Views
Public network PIM view
Default command level
2: System level
Parameters
interval: Specifies a register probe time in seconds. The value ranges from 1 to 1799.
Examples
# Set the register probe time to 6 seconds on the public network.