F3726, F3211, F3174, R5135, R3816-HP Firewalls and UTM Devices Network Management Command Reference-6PW100

650
<Sysname> system-view
[Sysname] pim
[Sysname-pim] probe-interval 6
Related commands
register-suppression-timeout
prune delay (PIM view)
Use prune delay to configure the prune delay time, namely, the length of time that the device waits
between receiving a prune message and taking a prune action.
Use undo prune delay to restore the default.
Syntax
prune delay interval
undo prune delay
Default
The prune delay time is not configured.
Views
Public network PIM view
Default command level
2: System level
Parameters
interval: Specifies a prune delay time in seconds, in the range of 1 to 128.
Examples
# Set the prune delay time to 75 seconds on the public network.
<Sysname> system-view
[Sysname] pim
[Sysname-pim] prune delay 75
register-policy (PIM view)
Use register-policy to configure an ACL rule to filter register messages.
Use undo register-policy to remove the configured register filtering rule.
Syntax
register-policy acl-number
undo register-policy
Default
No register filtering rule is configured.
Views
Public network PIM view