F3726, F3211, F3174, R5135, R3816-HP Firewalls and UTM Devices Network Management Command Reference-6PW100

801
OSPFv3 configuration commands
The term "router" in this document refers to both routers and routing-capable firewalls and UTM devices.
Feature and hardware compatibility
Hardware OSPFv3 com
p
atible
F1000-A-EI/F1000-S-EI Yes
F1000-E Yes
F5000 Yes
Firewall module Yes
U200-A Yes
U200-S No
abr-summary (OSPFv3 area view)
Use abr-summary to configure an IPv6 summary route on an area border router.
Use undo abr-summary to remove an IPv6 summary route. Then the summarized routes are advertised.
Syntax
abr-summary ipv6-address prefix-length [ not-advertise ]
undo abr-summary ipv6-address prefix-length
Default
No route summarization is available on an ABR.
Views
OSPFv3 area view
Default command level
2: System level
Parameters
ipv6-address: Destination IPv6 address of the summary route.
prefix-length: Prefix length of the destination IPv6 address, in the range of 0 to 128. This argument
specifies the number of consecutive 1s of the prefix, which defines the network ID.
not-advertise: Specifies not to advertise the summary IPv6 route.
Usage guidelines
You can use this command only on an ABR to configure a summary route for the area. The ABR advertises
only the summary route to other areas. Multiple contiguous networks may be available in an area, where
you can summarize them with one route for advertisement.