F3726, F3211, F3174, R5135, R3816-HP Firewalls and UTM Devices Network Management Command Reference-6PW100

832
[Sysname-GigabitEthernet0/1] ospfv3 1 area 1 instance 1
ospfv3 bfd enable
Use ospfv3 bfd enable to enable BFD for link failure detection on an OSPFv3 interface.
Use undo ospfv3 bfd enable to disable BFD on the OSPFv3 interface.
Syntax
ospfv3 bfd enable [ instance instance-id ]
undo ospfv3 bfd enable [ instance instance-id ]
Default
The OSPFv3 interface is not enabled with BFD.
Views
Interface view
Default command level
2: System level
Parameters
instance-id: Specifies the instance ID of an interface, in the range of 0 to 255. The default is 0.
Usage guidelines
The following matrix shows the ospfv3 bfd enable command and firewalls and UTM devices
compatibility:
Hardware Command com
p
atible
F1000-A-EI/F1000-S-EI No
F1000-E No
F5000 Yes
Firewall module No
U200-A No
U200-S No
Examples
# Enable BFD on GigabitEthernet 1/1 in instance 1.
<Sysname> system-view
[Sysname] interface gigabitethernet 1/1
[Sysname-GigabitEthernet1/1] ospfv3 bfd enable instance 1
ospfv3 cost
Use ospfv3 cost to configure the OSPFv3 cost of the interface in an instance.
Use undo ospfv3 cost to restore the default OSPFv3 cost of the interface in an instance.
Syntax
ospfv3 cost value [ instance instance-id ]