F3726, F3211, F3174, R5135, R3816-HP Firewalls and UTM Devices Network Management Command Reference-6PW100

63
Views
Ethernet interface view, Layer 2 aggregate interface view
Default command level
2: System level
Parameters
vlan-list: Specifies a list of VLANs that the trunk ports will be assigned to in the format of { vlan-id1 [ to
vlan-id2 ] }&<1-10>, where vlan-id1 and vlan-id2 represent VLAN IDs and each range from 1 to 4094,
vlan-id2 must be no smaller than vlan-id1, and &<1-10> indicates that you can specify up to 10 vlan-id1
[ to vlan-id2 ] parameters. Make sure the specified VLANs already exist.
all: Permits all VLANs to pass through the trunk ports.
Usage guidelines
A trunk port can carry multiple VLANs. If you execute the port trunk permit vlan command multiple times,
the trunk port carries the set of VLANs specified by vlan-list in each execution.
On a trunk port, only traffic of the PVID can pass through untagged.
To prevent unauthorized VLAN users from accessing restricted resources, use the port trunk permit vlan
all command with caution.
The configuration made in Ethernet interface view applies only to the port.
The configuration made in Layer 2 aggregate interface view applies to the aggregate interface and its
aggregation member ports.
• If the system fails to apply the configuration to the aggregate interface, it stops applying the
configuration to aggregation member ports.
• If the system fails to apply the configuration to an aggregation member port, it skips the port and
moves to the next member port.
Examples
# Assign the trunk port GigabitEthernet 0/1 to VLAN 2, VLAN 4, and VLAN 50 through VLAN 100.
<Sysname> system-view
[Sysname] interface gigabitethernet 0/1
[Sysname-GigabitEthernet0/1] port link-type trunk
[Sysname-GigabitEthernet0/1] port trunk permit vlan 2 4 50 to 100
Please wait........... Done.
# Assign the trunk Layer 2 aggregate interface Bridge-Aggregation 1 to VLAN 2.
<Sysname> system-view
[Sysname] interface bridge-aggregation 1
[Sysname-Bridge-Aggregation1] port link-type trunk
[Sysname-Bridge-Aggregation1] port trunk permit vlan 2
Please wait... Done.
Configuring GigabitEthernet0/1... Done.
Configuring GigabitEthernet0/2... Done.
Configuring GigabitEthernet0/3... Done.
The output shows that GigabitEthernet 0/1, GigabitEthernet 0/2, and GigabitEthernet 0/3 are the
member ports of the aggregation group corresponding to Bridge-Aggregation 1.