F3726, F3211, F3174, R5135, R3816-HP Firewalls and UTM Devices Network Management Command Reference-6PW100

940
IPv6 policy-based routing configuration
commands
Feature and hardware compatibility
Hardware Feature com
p
atible
F1000-A-EI/F1000-S-EI Yes
F1000-E Yes
F5000 Yes
Firewall module Yes
U200-A Yes
U200-S No
apply default output-interface
Use apply default output-interface to set a default output interface.
Use undo apply default output-interface to remove the configuration.
Syntax
apply default output-interface interface-type interface-number
undo apply default output-interface [ interface-type interface-number ]
Views
IPv6 policy node view
Default command level
2: System level
Parameters
interface-type interface-number: Specifies an interface by its type and number.
Usage guidelines
This command only applies to packets that do not find a match in the routing table. You can specify up
to five default output interfaces for per-flow load balancing.
With an interface specified, the undo apply default output-interface command removes the specified
default output interface.
Without any interface specified, the undo apply default output-interface command removes all default
output interfaces.
Examples
# Set GigabitEthernet 0/1 as the default output interface.