F3726, F3211, F3174, R5135, R3816-HP Firewalls and UTM Devices Network Management Configuration Guide-6PW100

Figure 52 Configuring global MSTP parameters on Device A

1128BConfiguring Device B

1. Configure the MST region name as example, map VLAN 10, VLAN 30, and VLAN 40 to MSTI 1,

MSTI 3, and MSTI 4, respectively, and configure the revision level of the MST region as 0. (The

procedure here is the same as that of configuring an MST region on Device A.)

2. Enable MSTP globally and configure the current device as the root bridge of MSTI 3:

a. Select Network > MSTP > Global from the navigation tree.

b. Perform the following configurations on the page similar to that shown in 2231HFigure 52:

{ Select Enable from the Enable STP Globally list.

{ Select MSTP from the Mode list.

{ Select the Instance box.

{ Set the Instance ID field to 3.

{ Set the Root Type field to Primary.

c. Click Apply.