F3726, F3211, F3174, R5135, R3816-HP Firewalls and UTM Devices Network Management Configuration Guide-6PW100

110
450BEnabling PPP encapsulation on an interface
The following matrix shows the feature and hardware compatibility:
Hardware Feature com
p
atible
F1000-A-EI/F1000-S-EI Yes
F1000-E No
F5000 No
Firewall module No
U200-A Yes
U200-S Yes
To enable PPP encapsulation on an interface:
Ste
p
Command Remarks
192. Enter system view.
system-view N/A
193. Enter interface view.
interface interface-type
interface-number
N/A
194. Enable PPP
encapsulation on the
interface.
link-protocol ppp
Optional.
Only dialer interfaces support this command.
By default, dialer interfaces use PPP as the link layer
protocol.
451BConfiguring PPP authentication
You can configure several authentication modes simultaneously. In LCP negotiation, the authenticator
negotiates with the supplicant in the sequence of configured authentication modes until the LCP
negotiation succeeds. If the response packet from the supplicant carries a recommended authentication
mode, the authenticator directly uses the authentication mode if it finds the mode configured.
1162BConfiguring PAP authentication
1. Configuring the authenticator
Ste
p
Command Remarks
195. Enter system view. system-view N/A
196. Enter interface view.
interface
interface-type interface-number
N/A
197. Configure the local device
to authenticate the
supplicant by using PAP.
ppp authentication-mode pap
[ [
call-in
]
domain
isp-name ]
By default, PPP
authentication is disabled.