F3726, F3211, F3174, R5135, R3816-HP Firewalls and UTM Devices Network Management Configuration Guide-6PW100

122
456BConfiguring PPP user binding
This function binds users in different domains with VT interfaces without knowing the domains of the users.
This feature is implemented in the following steps:
• Without knowing user domains, you must first authenticate users. If a user passes the authentication,
you can obtain the user domain name. The domain name varies with authentication results. For
more information, see authentication modes in "
2319HConfiguring PPP authentication."
• If PPP user binding is enabled on an interface, the interface binds the user to a corresponding VT
interface according to the binding rules and obtained domain name, and creates a VA interface for
protocol negotiation and packet transmission at the network layer.
To configure PPP user binding:
Ste
p
Command Remarks
274. Enter system view. system-view N/A
275. Enter VT interface view.
interface virtual-template
interface-number
N/A
276. Configure the local end
to authenticate the peer
end by using PAP, CHAP,
MS-CHAP, or
MS-CHAP-V2.
ppp authentication-mode { chap |
ms-chap | ms-chap-v2 | pap } *
By default, no authentication is
performed.
When configuring this command, do
not specify the domain by using the
domain keyword.
277. Enable PPP user binding.
ppp user bind enable The default setting is disabled.
278. Configure the PPP user
binding rules.
ppp user bind virtual-template
number domain domainname
By default, no PPP user binding rules
are configured.
86B
Displaying and maintaining PPP
Task Command Remarks
Display PPP user binding
information.
display ppp user bind [ virtual-template number ] [ |
{ begin | exclude | include } regular-expression ]
Available in any view.
Display information about a
VA interface or all the VA
interfaces on a VT interface.
display virtual-access [ va-number | dialer
dialer-number | peer peer-address | user user-name
| vt vt-number ] * [ | { begin | exclude | include }
regular-expression ]
Available in any view.
Display information about
an existing VT interface.
display interface virtual-template number [ brief ] [ |
{ begin | exclude | include } regular-expression ]
display interface [ virtual-template ] [ brief [ down ] ]
[ | { begin | exclude | include } regular-expression ]
Available in any view.
Clear statistics on a
specified interface.
reset counters interface [ virtual-template
[ interface-number ] ]
Available in user view.