F3726, F3211, F3174, R5135, R3816-HP Firewalls and UTM Devices Network Management Configuration Guide-6PW100

130
You must enable the PPPoE protocol on the PPPoE server, configure the PPPoE username and
password, and assign an IP address to the peer end of the PPP connection. (Details not shown.)
1176BVerifying the configuration
1. View the summary about PPPoE client sessions on the PPPoE client:
a. Select Network > PPPoE > Session from the navigation tree.
b. Select Summary Information from the Information Type list.
2329HFigure 69 shows that the status of the PPPoE client session is PPPUP .This indicates that PPP
negotiation is complete.
Figure 69 PPPoE session summary
2. View information about the dialer interface on the PPPoE client:
Select Device Management > Interface from the navigation tree or select Network > PPPoE >
Client.
2330HFigure 70 shows that interface Dialer 1 already gets an IP address assigned by the PPPoE server.
Figure 70 Dialer interface information
92B
Configuring a PPPoE client at the CLI
The following matrix shows the feature and hardware compatibility: