F3726, F3211, F3174, R5135, R3816-HP Firewalls and UTM Devices Network Management Configuration Guide-6PW100

131
Hardware PPPoE client com
p
atible
F1000-A-EI/F1000-S-EI Yes
F1000-E Yes
F5000 Yes
Firewall module Yes
U200-A Yes
U200-S No
PPPoE client configuration includes dialer interface configuration and PPPoE session configuration.
464BConfiguring a dialer interface
Before establishing a PPPoE session, you must first create a dialer interface and configure a dialer bundle
on the interface. Each PPPoE session uniquely corresponds to a dialer bundle and each dialer bundle
uniquely corresponds to a dialer interface. A PPPoE session uniquely corresponds to a dialer interface.
1177BConfiguring a dialer interface for an IPv4 PPPoE client
Ste
p
Command
279. Enter system view. system-view
280. Configure a dialer rule.
dialer-rule dialer-group { protocol-name { deny | permit }
| acl acl-number }
281. Create a dialer interface and enter its view.
interface dialer number
282. Create a dialer user. dialer user username
283. Assign an IP address to the interface.
ip address { address mask | ppp-negotiate }
284. Associate the interface with a dialer bundle.
dialer bundle bundle-number
285. Assign the interface to a dialer group. dialer-group group-number
1178BConfiguring a dialer interface for an IPv6 PPPoE client
Ste
p
Command
286. Enter system view. system-view
287. Enable IPv6 forwarding.
ipv6
288. Create a dialer interface and enter its view.
interface dialer number
289. Create a dialer user. dialer user username
290. Specify an IPv6 address for the interface.
See "Configuring IPv6 basics."
291. Associate the interface with a dialer bundle. dialer bundle bundle-number
You can also configure PPP authentication or set other parameters on the dialer interface as needed.
For information about more IPv6-related commands, see "IPv6 basics configuration commands."