F3726, F3211, F3174, R5135, R3816-HP Firewalls and UTM Devices Network Management Configuration Guide-6PW100

132
465BConfiguring a PPPoE session
PPPoE sessions fall into these categories:
• Permanent PPPoE session—Established immediately when the line is physically up. It remains valid
till a user terminates it explicitly.
• Packet-triggered PPPoE session—Established when there is a demand for data transmitting. It is
terminated when idled for a specific period of time. That is, a packet-triggered PPPoE session may
not be established even if the line is physically up.
You can establish a PPPoE session on an Ethernet port or a VE interface created on an ADSL interface.
To enable a device to access the Internet through an ADSL interface, establish a PPPoE session on a
virtual Ethernet interface. To enable a device to access the Internet through an ADSL modem attached to
an Ethernet interface, you must establish the PPPoE session on the Ethernet interface.
You can establish multiple PPPoE sessions on an Ethernet interface. In other words, an Ethernet interface
can belong to multiple dialer bundles at the same time. However, a dialer bundle can only have one
Ethernet interface. A PPPoE session uniquely corresponds to a dialer bundle, and vice versa.
IPv6 PPPoE sessions cannot be packet-triggered PPPoE sessions.
To configure a PPPoE session:
Ste
p
Command Remarks
292. Enter system view.
system-view N/A
293. Enter Ethernet interface view.
interface interface-type interface-number N/A
294. Create a PPPoE session, and
specify a dialer bundle for the
session.
pppoe-client dial-bundle-number number
[ no-hostuniq ] | idle-timeout seconds
[ queue-length packets ]
By default, no PPPoE
sessions are created.
466BDisplaying and maintaining PPPoE
Task Command Remarks
Display the statistics and state
information about a PPPoE client.
display pppoe-client session
{
packet
|
summary
} [
dial-bundle-number
number ] [
|
{
begin
|
exclude
|
include
}
regular-expression ]
Available in any view.
Reset PPP sessions on the PPPoE
client and reinitiate sessions.
reset pppoe-server { all |
dial-bundle-number number }
Available in user view.
467BPPPoE client configuration example
1179BNetwork requirements
As shown in 2331HFigure 71, configure Router to authenticate Firewall by using PAP or CHAP.