F3726, F3211, F3174, R5135, R3816-HP Firewalls and UTM Devices Network Management Configuration Guide-6PW100

135

Figure 72 Network diagram

1183BConfiguration procedure

1. Configure Firewall as a PPPoE client:

# Configure a dialer interface.

<Firewall> system-view

[Firewall] dialer-rule 1 ip permit

[Firewall] interface dialer 1

[Firewall-Dialer1] dialer-group 1

[Firewall-Dialer1] dialer bundle 1

[Firewall-Dialer1] ip address ppp-negotiate

[Firewall-Dialer1] ppp pap local-user user1 password cipher 123456

[Firewall-Dialer1] quit

# Configure a PPPoE session.

[Firewall] interface gigabitethernet 0/1

[Firewall-GigabitEthernet0/1] pppoe-client dial-bundle-number 1

[Firewall-GigabitEthernet0/1] quit

# Configure an Internet interface for the LAN and configure the default route.

[Firewall] interface gigabitethernet 0/2

[Firewall-GigabitEthernet0/2] ip address 192.168.1.1 255.255.255.0

[Firewall-GigabitEthernet0/2] quit

[Firewall] ip route-static 0.0.0.0 0 dialer 1

If the IP addresses of the hosts in the LAN are private addresses, configure NAT on Firewall. For

more information about NAT, see NAT and ALG Configuration Guide.

2. Configure Router as the PPPoE server:

# Add a PPPoE user.

<Router> system-view

[Router] local-user user1

[Router-luser-user1] password simple 123456

[Router-luser-user1] service-type ppp

[Router-luser-user1] quit