F3726, F3211, F3174, R5135, R3816-HP Firewalls and UTM Devices Network Management Configuration Guide-6PW100

139
Figure 74 Adding an inline forwarding policy
3. Configure the inline forwarding policy as described in 2333HTable 20.
4. Click Apply.
Table 20 Configuration items
Item Descri
p
tion
Policy ID Set the ID for identifying an inline forwarding policy.
Policy Type Select the inline forwarding type, which can be forward, blackhole, or reflect.
Port 1 Assign a port to the inline forwarding policy.
Port 2 Assign a port to the inline forwarding policy when the forwarding type is Forward.
1185BForward-type inline forwarding configuration example
1. Network requirements
Packets received on GigabitEthernet 0/1 need to be forwarded from GigabitEthernet 0/2, and packets
received on GigabitEthernet 0/2 need to be forwarded from GigabitEthernet 0/1. Configure
forward-type inline forwarding between GigabitEthernet 0/1 and GigabitEthernet 0/2.
Before configuration, make sure the GigabitEthernet 0/1 and GigabitEthernet 0/2 interfaces operate in
bridge mode and have been added to zones.
2. Adding a forward-type inline forwarding policy
a. Select Network > Forwarding from the navigation tree.
b. Click Add to enter the page for adding an inline forwarding policy.
c. Type policy ID 1, select Forward from the Policy Type list, select GigabitEthernet0/1 from the
Port 1 list, and select GigabitEthernet0/2 from the Port 2 list.
d. Click Apply.