F3726, F3211, F3174, R5135, R3816-HP Firewalls and UTM Devices Network Management Configuration Guide-6PW100

144
Ste
p
Command Remarks
309. Create a VLAN for the
firewall module and enter
VLAN view.
vlan vlan-id N/A
310. Exit to system view.
quit N/A
311. Enter the view of the
ten-GigabitEthernet
interface that connects to the
switch.
interface ten-gigabitethernet
interface-number
N/A
312. Configure the operating
mode of the interface as
Layer 2.
port link-mode bridge
The default operating mode
depends on the device model.
313. Configure the link type of the
ten-GigabitEthernet
interface as trunk.
port link-type trunk N/A
314. Assign the trunk port to the
specified VLANs.
port trunk permit vlan { vlan-id-list
| all }
The VLAN of the firewall module
and the VLANs where the
subinterfaces of the
ten-GigabitEthernet interface reside
must be included.
315. Create a subinterface of the
ten-GigabitEthernet
interface and enter
subinterface view.
interface ten-gigabitethernet
interface-number.subnumber
The subnumber must be one of the
VLAN IDs created on the switch.
316. Configure the operating
mode of the subinterface as
Layer 2.
port link-mode bridge
The default operating mode
depends on the device model.
317. Configure the link type of the
subinterface as access.
port link-type access
Optional.
By default, the link type of a
subinterface is access.
318. Assign the subinterface to
the VLAN of the firewall
module.
port access vlan vlan-id N/A
319. Create another subinterface
and enter subinterface view.
interface ten-gigabitethernet
interface-number.subnumber
The subnumber must be the ID of the
other VLAN created on the switch.
320. Configure the operating
mode of the subinterface as
Layer 2.
port link-mode bridge
The default operating mode
depends on the device model.
321. Configure the link type of the
subinterface as access.
port link-type access
Optional.
By default, the link type of a
subinterface is access.
322. Assign the subinterface to
the VLAN of the firewall
module.
port access vlan vlan-id N/A