F3726, F3211, F3174, R5135, R3816-HP Firewalls and UTM Devices Network Management Configuration Guide-6PW100

176
Ste
p
Command Remarks
362. Enter DHCP address
pool view.
dhcp server ip-pool pool-name
[ extended ]
N/A
363. Specify gateways.
gateway-list ip-address&<1-8>
No gateway is specified by default.
You can specify up to eight gateways in a
DHCP address pool.
1214BConfiguring the TFTP server and bootfile name for the client
For the DHCP server to support client auto-configuration, specify the IP address or name of a TFTP server
and the bootfile name in the DHCP address pool. You do not need to perform any configuration on the
DHCP client.
The DHCP client obtains these parameters from the DHCP server, and uses them to contact the TFTP
server to request the configuration file used for system initialization.
1. When a router starts up without loading any configuration file, the system sets an active interface
(such as the interface of the default VLAN or a Layer 3 Ethernet interface) as the DHCP client to
request from the DHCP server for parameters, such as an IP address and name of a TFTP server,
and the bootfile name.
2. After receiving related parameters, the DHCP client sends a TFTP request to obtain the
configuration file from the specified TFTP server for system initialization. If the client cannot get
such parameters, it performs system initialization without loading any configuration file.
To configure the IP address and name of the TFTP server and the bootfile name in the DHCP address
pool:
Ste
p
Command Remarks
364. Enter system view. system-view N/A
365. Enter DHCP address pool
view.
dhcp server ip-pool pool-name
[ extended ]
N/A
366. Specify the IP address or the
name of the TFTP server.
• Specify the TFTP server:
tftp-server ip-address ip-address
• Specify the name of the TFTP server:
tftp-server domain-name
domain-name
Use either command.
Not specified by default.
367. Specify the bootfile name.
bootfile-name bootfile-name Not specified by default.
1215BSpecifying a server's IP address for the DHCP client
Some DHCP clients need to obtain configuration information from a server, such as a TFTP server. You
can specify the IP address of that server in each address pool of the DHCP server. The DHCP server sends
the server's IP address to DHCP clients along with other configuration information.
To specify the IP address of a server:
Ste
p
Command Remarks
368. Enter system view.
system-view N/A
369. Enter DHCP address pool view.
dhcp server ip-pool pool-name
[ extended ]
N/A