F3726, F3211, F3174, R5135, R3816-HP Firewalls and UTM Devices Network Management Configuration Guide-6PW100

242
17BConfiguring ARP
This chapter describes how to configure the Address Resolution Protocol (ARP).
The term "router" in this document refers to both routers, routing-capable firewalls, and UTM devices.
126B
Overview
ARP resolves IP addresses into physical addresses such as MAC addresses. On an Ethernet LAN, a
device uses ARP to get the MAC address of the target device for a packet.
561BARP message format
ARP uses two types of messages, ARP request and ARP reply. 2468HFigure 157 shows the format of the ARP
request/reply. Numbers in the figure refer to field lengths.
Figure 157 ARP message format
• Hardware type—Hardware address type. The value 1 represents Ethernet.
• Protocol type—Type of the protocol address to be mapped. The hexadecimal value 0x0800
represents IP.
• Hardware address length and protocol address length—Length, in bytes, of a hardware address
and a protocol address. For an Ethernet address, the value of the hardware address length field is
6. For an IPv4 address, the value of the protocol address length field is 4.
• OP—Operation code, which describes type of the ARP message. Value 1 represents an ARP request,
and value 2 represents an ARP reply.
• Sender hardware address—Hardware address of the device sending the message.
• Sender protocol address—Protocol address of the device sending the message.
• Target hardware address—Hardware address of the device to which the message is being sent.
• Target protocol address—Protocol address of the device to which the message is being sent.
562BARP operation
As shown in 2469HFigure 158, Host A and Host B are on the same subnet. Host A sends a packet to Host B as
follows: