F3726, F3211, F3174, R5135, R3816-HP Firewalls and UTM Devices Network Management Configuration Guide-6PW100

4
364BCreating an interface
1. Select Device Management > Interface from the navigation tree.
2. Click Add to enter the page for creating an interface.
Figure 3 Creating an interface
3. Configure the interface information as described in 2151HTable 1.
4. Click Apply.
Table 1 Configuration items
Item Descri
p
tion
Interface Name
Set the name for the interface or its subinterface.
• If you select a logical interface type from the list, such as Dialer, LoopBack,
Tunnel, Vlan-interface, Virtual-Template, Route-Aggregation, or
Bridge-Aggregation, set the interface number in the box behind to create
the logical interface.
• If you select a specific Ethernet interface name from the list, such as
GigabitEthernet 0/1, set the subinterface number in the box behind to
create a subinterface of the Ethernet interface.
• If you select a specific RAGG interface name from the list, such as
Route-Aggregation, set the subinterface number in the box behind to create
a subinterface of the RAGG interface.