F3726, F3211, F3174, R5135, R3816-HP Firewalls and UTM Devices Network Management Configuration Guide-6PW100

283
Figure 184 Creating a classification rule for a class
3. Configure the classification rule as described in 2501HTable 38.
4. Click Apply.
Table 38 Configuration items
Item Descri
p
tion
Classifier Name Displays the name of the class you are configuring.
ACL
Define an ACL-based match criterion, and specify the ACL by number.
You can select or enter an ACL number. The available ACLs are those
configured in Firewall > ACL. For information about configuring an ACL, see
Access Control Configuration Guide.
If the specified ACL does not exist, you can successfully configure the match
criterion, but it does not take effect.
Protocol group
Define a criterion to match a protocol group.
If the specified protocol group ID does not exist, you can successfully modify
the match criterion, but it does not take effect.
The protocol group configuration item is not supported.
Source MAC Address
Define a criterion to match the specified source MAC address.
A criterion to match a source MAC address is applicable only to Ethernet
interfaces.
Destination MAC Address
Define a criterion to match the specified destination MAC address.
A criterion to match a destination MAC address is applicable only to Ethernet
interfaces.
Customer 802.1p
Define a criterion to match the specified customer 802.1p priority value or
values.
You can enter up to eight 802.1p priority values, and the logical relationship
between different 802.1p priority values is OR.