F3726, F3211, F3174, R5135, R3816-HP Firewalls and UTM Devices Network Management Configuration Guide-6PW100

291
150B
Configuring a QoS policy at the CLI
2505HFigure 195 shows how to configure a QoS policy.
Figure 195 QoS policy configuration procedure
603BDefining a class
Ste
p
Command Remarks
21. Enter system view.
system-view N/A
22. Create a class and
enter class view.
traffic classifier
classifier-name [ operator
{ and | or } ]
By default, the operator of a class is AND.
The operator of a class can be AND or OR.
• AND—A packet is assigned to a class only when
the packet matches all the criteria in the class.
• OR—A packet is assigned to a class if it matches
any of the criteria in the class.
23. Configure match
criteria.
if-match [ not ]
match-criteria
For more information, see the if-match command in
ACL and QoS Command Reference.
604BDefining a traffic behavior
A traffic behavior is a set of QoS actions to take on a class of traffic.
To define a traffic behavior:
Ste
p
Command
24. Enter system view.
system-view
25. Create a traffic behavior and
enter traffic behavior view
traffic behavior behavior-name
26. Configure actions in the traffic
behavior.
See the subsequent chapters, depending on the purpose of the traffic
behavior.