F3726, F3211, F3174, R5135, R3816-HP Firewalls and UTM Devices Network Management Configuration Guide-6PW100

294
Figure 196 Configuring line rate on a port
3. Configure the line rate as described in 2506HTable 42.
4. Click Apply.
Table 42 Configuration items
Item Descri
p
tion
Please select an interface type Select the interface type to be configured with line rate.
Rate Limit Enable or disable line rate on the specified port.
Direction
Select a direction in which the line rate is to be applied.
• Inbound—Limits the rate of packets received on the specified port.
• Outbound—Limits the rate of packets sent by the specified port.
CIR
Set the CIR, which is the average traffic
rate.
For bursty traffic to be
handled effectively, make
sure the ratio of CBS to
CIR is at least 100:16.
CBS
Set the CBS, which is the number of bits that
can be sent in each interval.
EBS
Set the EBS.
This configuration item is not supported.
Please select port(s) Select the port or ports to be configured with line rate from the port list.