F3726, F3211, F3174, R5135, R3816-HP Firewalls and UTM Devices Network Management Configuration Guide-6PW100

320
Ste
p
Command
43. Associate the class with the traffic behavior in
the QoS policy.
classifier classifier-name behavior behavior-name
44. Return to system view.
quit
45. Apply the QoS policy to an interface.
2516H
Applying the QoS policy to an interface
617BConfiguring traffic policing by using non-policy approach
1329BConfiguring CAR-list-based traffic policing
Ste
p
Command Remarks
46. Enter system view.
system-view N/A
47. Configure a CAR
list.
qos carl carl-index { destination-ip-address |
source-ip-address } { subnet ip-address mask-length
| range start-ip-address to end-ip-address }
[ per-address [ shared-bandwidth ] ] }
Configure rules on the CAR
list.
48. Enter interface view.
interface interface-type interface-number N/A
49. Configure a CAR list
based CAR policy
on the interface.
qos car { inbound | outbound } carl carl-index cir
committed-information-rate [ cbs
committed-burst-size [ ebs excess-burst-size ] ]
[ green action ] [ red action ]
N/A
1330BConfiguring ACL-based traffic policing
Ste
p
Command Remarks
50. Enter system view.
system-view N/A
51. Configure an ACL.
See Access Control Configuration Guide. Configure rules for the ACL.
52. Enter interface view.
interface interface-type interface-number N/A
53. Configure an ACL
based CAR policy on
the interface.
qos car { inbound | outbound } acl [ ipv6 ]
acl-number cir committed-information-rate
[ cbs committed-burst-size [ ebs
excess-burst-size ] ] [ green action ] [ red
action ]
N/A
NOTE:
Support for the ipv6 keyword
depends the device model. For
more information, see this
command in Network Management
Command Reference.
1331BConfiguring traffic policing for all traffic
Ste
p
Command Remarks
54. Enter system view.
system-view N/A
55. Enter interface view.
interface interface-type interface-number
N/A