F3726, F3211, F3174, R5135, R3816-HP Firewalls and UTM Devices Network Management Configuration Guide-6PW100

329
Table 46 Configuration items
Item Descri
p
tion
Destination IP Address
Enter the destination IP address in
dotted decimal notation.
IMPORTANT:
You can enter 0.0.0.0 for both
Destination IP Address and Mask to
configure a default route. A default route
is used to forward packets that match no
route entry in the routing table.
Mask Enter the destination IP address mask.
Next Hop Enter the next hop IP address in dotted decimal notation.
Outbound Interface Enter the outbound interface.
Priority
Enter the static route priority.
The static route priority defaults to 60.
621BStatic route configuration example
In this example, Device A is the firewall.
1334BNetwork requirements
Configure IP addresses and masks for the interfaces and hosts as shown in 2520HFigure 238. Configure static
routes between the hosts so that any two hosts can communicate with each other.
Figure 238 Network diagram
1335BConfiguration procedure
1. Configure the IP addresses of the hosts, and configure the default gateways of Host A, Host B and
Host C as 1.1.2.3, 1.1.6.1 and 1.1.3.1. (Details not shown.)
2. Configure IP addresses for interfaces and add interfaces to the security zones. (Details not shown.)
3. Configure a static route to Device B on Device A:
a. Select Network > Routing Management > Static Routing from the navigation tree.
b. Click Add.
The page for configuring a static route appears.