F3726, F3211, F3174, R5135, R3816-HP Firewalls and UTM Devices Network Management Configuration Guide-6PW100

332
Ste
p
Command Remarks
61. Configure the
default preference
for static routes.
ip route-static default-preference
default-preference-value
Optional.
60 by default.
62. Delete all static
routes, including
the default route.
delete [ vpn-instance vpn-instance-name ] static-routes
all
Optional.
To delete one static route,
use the undo ip
route-static command.
622BConfiguring BFD for static routes
The following matrix shows the feature and hardware compatibility:
Hardware Feature com
p
atible
F1000-A-EI/F1000-S-EI No
F1000-E No
F5000 Yes
Firewall module No
U200-A No
U200-S No
IMPORTANT:
Enabling BFD for a flapping route could worsen the situation.
BFD provides a general-purpose, standard, medium-, and protocol-independent fast failure detection
mechanism. It can uniformly and quickly detect the failures of the bidirectional forwarding paths between
two routers for protocols, such as routing protocols.
For more information about BFD, see High Availability Configuration Guide.
1337BConfiguring bidirectional control mode
To use BFD bidirectional control detection between two devices, enable BFD control mode for each
device's static route destined to the peer.
To configure a static route and enable BFD control mode for it, specify an output interface and a direct
next hop, or specify an indirect next hop and a specific BFD packet source address for the static route.
To configure BFD control mode for a static route (direct next hop):
Ste
p
Command Remarks
63. Enter system view.
system-view
N/A