F3726, F3211, F3174, R5135, R3816-HP Firewalls and UTM Devices Network Management Configuration Guide-6PW100

349
165B
Configuring RIP at the CLI
631BRIP configuration task list
Task Remarks
2530H
Configuring basic RIP Required
2531H
Configuring
RIP route
control
2532H
Configuring an additional routing metric Optional
2533H
Configuring RIPv2 route summarization Optional
2534H
Disabling host route reception Optional
2535H
Advertising a default route Optional
2536H
Configuring received/redistributed route filtering Optional
2537H
Configuring a preference for RIP Optional
2538H
Configuring RIP route redistribution Optional
2539H
Tuning and
optimizing
RIP
networks
2540H
Configuring RIP timers Optional
2541H
Configuring split horizon and poison reverse Optional
2542H
Configuring the maximum number of ECMP routes Optional
2543H
Enabling zero field check on incoming RIPv1 messages Optional
2544H
Enabling source IP address check on incoming RIP updates Optional
2545H
Configuring RIPv2 message authentication Optional
2546H
Specifying a RIP neighbor Optional
2547H
Configuring RIP-to-MIB binding Optional
2548H
Configuring the RIP packet sending rate Optional
2549H
Configuring
BFD for RIP
2550H
Configuring single-hop echo detection (for a directly connected RIP neighbor) Optional
2551H
Configuring single-hop echo detection (for a specific destination) Optional
2552H
Configuring bidirectional control detection Optional
632BConfiguring basic RIP
Before you configure basic RIP settings, complete the following tasks:
• Configure the link layer protocol.
• Configure IP addresses for interfaces to ensure IP connectivity between neighboring routers.
1349BEnabling RIP
Perform this task to create a RIP process and enable the RIP process on the interface attached to the
specified network. An interface that is not on the specified network does not run RIP.
If you configure RIP settings in interface view before enabling RIP, the settings do not take effect until RIP
is enabled. If a physical interface is attached to multiple networks, you cannot advertise these networks
in different RIP processes.
To enable RIP: