F3726, F3211, F3174, R5135, R3816-HP Firewalls and UTM Devices Network Management Configuration Guide-6PW100

358
Ste
p
Command Remarks
143. Enter RIP view.
rip [ process-id ] [ vpn-instance
vpn-instance-name ]
N/A
144. Specify a RIP neighbor. peer ip-address N/A
145. Disable source address check
on incoming RIP updates.
undo validate-source-address
By default, this function is not
disabled.
1367BConfiguring RIP-to-MIB binding
This task allows you to enable a specific RIP process to receive SNMP requests.
To bind RIP to MIB:
Ste
p
Command Remarks
146. Enter system view.
system-view N/A
147. Bind RIP to MIB. rip mib-binding process-id
Optional.
By default, MIB is bound to RIP process 1.
1368BConfiguring the RIP packet sending rate
Perform this task to specify the interval for sending RIP packets and the maximum number of RIP packets
that can be sent at each interval. This feature can avoid excessive RIP packets from affecting system
performance and consuming too much bandwidth.
To configure the RIP packet sending rate:
Ste
p
Command Remarks
148. Enter system view. system-view N/A
149. Enter RIP view.
rip [ process-id ] [ vpn-instance
vpn-instance-name ]
N/A
150. Specify the interval for sending
RIP packets and the maximum
number of RIP packets that can
be sent at each interval.
output-delay time count count
Optional.
By default, an interface sends up to
three RIP packets every 20
milliseconds.
635BConfiguring BFD for RIP
The following matrix shows the feature and hardware compatibility:
Hardware Feature com
p
atible
F1000-A-EI/F1000-S-EI No
F1000-E No
F5000 Yes
Firewall module No
U200-A No