F3726, F3211, F3174, R5135, R3816-HP Firewalls and UTM Devices Network Management Configuration Guide-6PW100

16
Ste
p
Command
27. Change the link mode of the Ethernet interface. port link-mode { bridge | route }
374BConfiguring jumbo frame support
The following matrix shows the feature and hardware compatibility:
Hardware Feature com
p
atible
F1000-A-EI/F1000-S-EI No
F1000-E No
F5000 No
Firewall module Yes
U200-A No
U200-S No
An Ethernet interface might receive some frames larger than the standard Ethernet frame size (called
"jumbo frames") during high-throughput data exchanges such as file transfers. Usually, an Ethernet
interface discards jumbo frames. With jumbo frame support enabled, the interface can process frames
larger than the standard Ethernet frame size yet within the specified range.
To configure jumbo frame support in system view:
Ste
p
Command Remarks
28. Enter system view.
system-view N/A
29. Enter interface view.
interface interface-type
interface-number
N/A
30. Configure jumbo frame
support.
jumboframe enable
[ value ]
By default, the device allows jumbo frames within
the specified length to pass through all Layer 2
Ethernet interfaces. The maximum length of jumbo
frames allowed to pass through depends on your
device model.
If you set the value argument multiple times, the
latest configuration takes effect.
375BEnabling subinterface rate statistics collection on an Ethernet
interface
The following matrix shows the feature and hardware compatibility:
Hardware Feature com
p
atible
F1000-A-EI/F1000-S-EI No
F1000-E Yes
F5000 Yes