F3726, F3211, F3174, R5135, R3816-HP Firewalls and UTM Devices Network Management Configuration Guide-6PW100

380
Figure 265 Configuring area 1
1388BConfiguring Device B
1. Configure IP addresses for interfaces and add interfaces to the security zones. (Details not shown.)
2. Enable OSPF:
a. Select Network > Routing Management > OSPF from the navigation tree of Device B.
b. Select the Enable OSPF box.
c. Click Apply.
3. Configure Normal area Area 0:
a. Click Add on the Area Configuration tab.
b. Enter 0 for Area ID, select Normal for Area Type, enter 10.1.1.0 for Network Address, select
0.0.0.255 for Network Mask, and click Add Network.
c. Click Apply.
4. Configure Normal area Area 2:
a. Click Add on the Area Configuration tab.
b. Enter 2 for Area ID, select Normal for Area Type, enter 10.3.1.0 for Network Address, select
0.0.0.255 for Network Mask, and click Add Network.
c. Click Apply.