F3726, F3211, F3174, R5135, R3816-HP Firewalls and UTM Devices Network Management Configuration Guide-6PW100

400
To configure OSPF network management:
Ste
p
Command Remarks
294. Enter system view.
system-view N/A
295. Bind OSPF MIB to an
OSPF process.
ospf mib-binding process-id
Optional.
The OSPF process with the smallest
process-id is bound with OSPF MIB
by default.
296. Enable OSPF trap
generation.
snmp-agent trap enable ospf [ process-id ]
[ ifauthfail | ifcfgerror | ifrxbadpkt |
ifstatechange | iftxretransmit |
lsdbapproachoverflow | lsdboverflow |
maxagelsa | nbrstatechange | originatelsa
| vifcfgerror | virifauthfail | virifrxbadpkt
| virifstatechange | viriftxretransmit |
virnbrstatechange ] *
Optional.
Enabled by default.
1427BEnabling message logging
Ste
p
Command Remarks
297. Enter system view.
system-view N/A
298. Enter OSPF view.
ospf [ process-id | router-id router-id |
vpn-instance vpn-instance-name ] *
N/A
299. Enable message
logging.
enable log [ config | error | state ]
By default, the function is
disabled.
1428BEnabling the advertisement and reception of opaque LSAs
With this feature enabled, OSPF can receive and advertise Type 9, Type 10, and Type 11 opaque LSAs.
To enable the advertisement and reception of opaque LSAs:
Ste
p
Command Remarks
300. Enter system view. system-view N/A
301. Enter OSPF view.
ospf [ process-id | router-id router-id |
vpn-instance vpn-instance-name ] *
N/A
302. Enable the advertisement and
reception of opaque LSAs.
opaque-capability enable
Optional.
By default, the
function is disabled.
1429BConfiguring OSPF to give priority to receiving and processing hello packets
To ensure OSPF runs properly, a router receives and processes hello packets and other protocol packets
at the same time. When the router has established neighbor relationships with multiple routers, and the
routing table size is big, the router must receive and process large numbers of packets. In this case, you
can configure OSPF to give priority to receiving and processing Hello packets to ensure stable neighbor
relationships.
To configure OSPF to give priority to receiving and processing Hello packets: