F3726, F3211, F3174, R5135, R3816-HP Firewalls and UTM Devices Network Management Configuration Guide-6PW100

401
Ste
p
Command Remarks
303. Enter system view. system-view N/A
304. Configure OSPF to give priority
to receiving and processing
hello packets.
ospf packet-process
prioritized-treatment
Not configured by default.
1430BConfiguring the LSU transmit rate
Sending large numbers of LSU packets affects router performance and consumes too much network
bandwidth. You can configure the router to send LSU packets at a proper interval and limit the maximum
number of LSU packets sent out of an OSPF interface each time.
To configure the LSU transmit rate:
Ste
p
Command Remarks
305. Enter system view.
system-view N/A
306. Enter OSPF view.
ospf [ process-id | router-id router-id |
vpn-instance vpn-instance-name ] *
N/A
307. Configure the LSU
transmit rate.
transmit-pacing interval interval count count
Optional.
By default, an OSPF interface
sends up to three LSU packets
every 20 milliseconds.
1431BEnabling OSPF ISPF
Upon topology changes, Incremental Shortest Path First (ISPF) computes only the affected part of the SPT,
instead of the entire SPT.
To enable OSPF ISPF:
Ste
p
Command Remarks
308. Enter system view.
system-view N/A
309. Enter OSPF view.
ospf [ process-id | router-id router-id |
vpn-instance vpn-instance-name ] *
N/A
310. Enable OSPF ISPF.
ispf enable
Optional.
By default, OSPF ISPF is disabled.
656BConfiguring BFD for OSPF
The following matrix shows the feature and hardware compatibility:
Hardware Feature com
p
atible
F1000-A-EI/F1000-S-EI No
F1000-E No
F5000 Yes
Firewall module No
U200-A No