F3726, F3211, F3174, R5135, R3816-HP Firewalls and UTM Devices Network Management Configuration Guide-6PW100

430
Task Remarks
2622H
Configuring IS-IS route leaking Optional
2623H
Configuring a DIS
priority for an
interface
2624H
Specifying intervals for sending IS-IS hello and CSNP packets Optional
2625H
Specifying the IS-IS hello multiplier Optional
2626H
Configuring a DIS priority for an interface Optional
2627H
Disabling an interface from sending/receiving IS-IS packets Optional
2628H
Disabling hello source address check for a PPP interface Optional
2629H
Enabling an interface to send small hello packets Optional
2630H
Configuring LSP parameters Optional
2631H
Configuring SPF parameters Optional
2632H
Configuring convergence priorities for specific routes Optional
2633H
Setting the LSDB overload bit Optional
2634H
Configuring system ID to host name mappings Optional
2635H
Enabling the logging of neighbor state changes Optional
2636H
Enhancing IS-IS
network security
2637H
Configuring neighbor relationship authentication Optional
2638H
Configuring area authentication Optional
2639H
Configuring routing domain authentication Optional
2640H
Enabling IS-IS SNMP trap Optional
2641H
Binding an IS-IS process with MIBs Optional
174B
Configuring basic IS-IS
This section describes the basic settings required for an IS-IS network to run.
669BConfiguration prerequisites
Before the configuration, complete the following tasks:
• Configure the link layer protocol.
• Configure IP addresses for all interfaces to ensure IP connectivity between neighboring nodes.
670BEnabling IS-IS
Ste
p
Command Remarks
318. Enter system view. system-view N/A
319. Enable an IS-IS routing
process and enter its view.
isis [ process-id ] [ vpn-instance
vpn-instance-name ]
By default, the IS-IS routing process
is disabled.
320. Assign a NET.
network-entity net By default, NET is not assigned.
321. Return to system view. quit N/A